Idex Hale Sam, Technical Manual

Page: 132 / 223

112
C. Using 9/16-in wrench, tighten elbow. (Use vise or 13/16-in wrench to hold sole-
noid.)
D. Apply Loctite 580 to threads of existing/new nipple.
(Use sealant sparingly to prevent check valve/solenoid damage.)
E. Install solenoid.
NOTE
Do NOT overtighten solenoid.
F. Hand tighten solenoid until snug.
G. Using 13/16-in wrench, torque an additional 1 turn (2 turns maximum) past hand
tight engagement.
H. Connect cooling water tube (3/8-in tubing) to elbow. Push tubing until locked.
I. Pressurize system to check for leaks.
J. Connect electric connector according to tags.
K. Install cable ties cut to R&R solenoid as noted.
4.10.4 DC-To-DC Converter
The DC-to-DC (12 to 24 VDC) converter (Figure 81) which connects to the SAM power bus and
provides 3 Amps (72 W) of 24 VDC power to the Wi-Fi router/antenna via the ethernet POE elec-
tric harness.
Figure 81. DC-To-DC Converter
The SAM DC-to-DC converter is installed by the OEM/apparatus builder, refer to the OEM/appa-
ratus builder documentation for converter location, mounting, and R&R information.
See Table 64 for the DC-to-DC (12 to 24 VDC) converter wiring connections.
Table 64. DC-To-DC Converter Wiring (From/To Listing)
From Converter
(Wire)
To Circuit Breaker Box
Connector 1 Pin
To Antenna
(Twisted Pair Of CAT 6 Cable)
Red 3 N/C
Black System Ground N/C
Black N/C Brown and Brown/White
Yellow N/C Blue and Blue/White
Refer to FSG-PL-01505, Sheet 3 for part number and harness connection information.