Idex Hale Sam, Technical Manual

Page: 162 / 223

142
If the Wi-Fi antenna/router you received does NOT automatically pair with your SAM Control Cen-
ter and/or your SAM tablet contact Hale Customer Service (800-533-3569) and inform Hale of
the problem.
4.12.6
ITL–40 Configuration Procedures
SAM uses the ITL–40 CAN address to display the tank level data of that ITL–40. The water tank,
foam tank A, and foam tank B should all have different addresses. Hale ships each SAM ITL–40
preaddressed and labeled appropriately (WATER, FOAM A, or FOAM B). For current production, all
ITL-40 addresses are set by the SAM software. If the ILT-40 was NOT provided directly by Hale
performing the applicable labeled procedure may allow the ITL-40 to communicate with SAM.
Figure 118. ITL–40 Address Switch Locations
The target areas are marked with a very small white dot on each side of the label (highlighted by
the red circles on Figure 118). Enter a L/R command string as provided in the following applica-
bly labeled subparagraphs. Note the following information for entering a L/R command string.
• The lights in the left-hand column will flash when an L is triggered.
•
The lights in the right-hand column will flash when an R is triggered.
•
An X pattern of lights will appear if an incorrect password is entered.
SAM is NOT compatible with any ITL-40 AutoFill configuration, do NOT configure a SAM (or foam
system installed on a SAM system) using an AutoFill password. Hale recommends using the cali-
bration procedures herein (NOT the Class 1 Operation Manual procedures) for ITL-40 read out
calibration. (See paragraph 5.4, page 181.)
4.12.6.1
Water Tank
For current production, all ITL-40 addresses are set by the SAM software. If the ILT-40 was NOT
provided directly by Hale performing the following may allow the ITL-40 to communicate with
SAM.
A.
Power SAM system on.