Idex Hale Sam, Technical Manual

Page: 119 / 223

99
Table 52. MIV–A Module Wiring (From/To Listing) – CONTINUED
Module Connector/Pin (From) Sensor Connector/Pin (To)
A Keyed Connector (Mates with Grey Harness Connector) – CONTINUED
7 (Pump Body Prime) [Output] A 4-Way Valve (Pump Body Prime) See Table 69
B Diode 2 See Table 56
8 (PB SW LED #2) [Output] 3 MIV-Auto Placard For LH MIV See Table 22
9 (Pre-Prime #1) [Output] A 4-Way Valve (RH MIV) See Table 69
10 (Auxiliary Output) [Output] N/C
11 (CAN Low) [Buss] Green CAN Bus Connector
12 (Ground) [Input] System Ground
B Keyed Connector (Mates with Black Harness Connector)
1 (AB Drain) [Output] A 4-Way Valve (SAM Air Bleed Drain) See Table 69
2 (Pre-Prime #2) [Output] A 4-Way Valve (LH MIV) See Table 69
3 (Primer Start) [Output] B Primer Solenoid
4 (Water In Primer Detect) [Input] C Water Detection Sensor (Primer) See Table 42
5 (Water Column Signal) [Input] C Pressure Sensor (Water Column) See Table 31
6 (SW-1 Momentary) [Input] 2 MIV-Auto Placard For RH MIV See Table 22
7 (SW-2 Momentary) [Input] 2 MIV-Auto Placard For LH MIV See Table 22
8 (SW-3 Momentary) [Input] 2 MIV-Auto Placard For Bottom MIV See Table 22
9 (+9 Reference) [Output] N/C
12 (Ground Reference) [Output] N/C
11 (+5 Reference) [Output] A Pressure Sensor (Water Column) See Table 31
12 (–5 V Reference) [Output] B Pressure Sensor (Water Column) See Table 31
NOTE: The POWER screw between the A and B connectors connects to circuit breaker box
connector 1 pin 3.
Refer to Table 45 for a list of tools and/or consumables required for this procedure.
Table 53. MIV–A Module Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
Wire Cutter Cable Ties (As Required)
7/16-in Wrench MIV–A Module
<See FSG-PL-01501, -01502, or -01513, Sheet 3>
#2 Phillips Screwdriver Loctite 580 (Or Equivalent)
If the module fails or is damaged; replace the module as follows.
Removal
A.
Note cable tie locations, cut ONLY ties required to R&R module.
B. Tag and disconnect electrical connectors.