Idex Hale Sam, Technical Manual

Page: 107 / 223

87
Table 44 provides the solenoids electrical connections.
Table 44. Zero Pressure Solenoid Wiring (From/To Listing)
From To Sensor Module, Connector A, Pin To Breaker Box
A N/C Connector 1 Pin 3
B N/C N/C
C 7 AUTOLUBE SOL NEG [Output] N/C
Refer to Table 45 for a list of tools and/or consumables required for this procedure.
Table 45. Zero Pressure Solenoid Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
Wire Cutter Cable Ties (As Required)
Slip Joint Plyers Zero Pressure Solenoid
<See FSG-PL- 01501, - 01502, Sheet 3>
9/16-in Wrench Brass Adapter
Adjustable Wrench (Optional) Loctite 580 (Or Equivalent)
If the solenoid fails or is damaged; replace the solenoid as follows.
Access
A.
Note cable tie locations, cut ONLY ties required to R&R both module brackets (in-
cluding modules), circuit breaker box, and solenoid.
B. At modules, circuit breaker box, sensor, and solenoid, tag and disconnect electric
connectors.
C. At top of Autolube assembly, remove both module mounting brackets.
See Figure 58.
Figure 58. Removal Of The Module Mounting Brackets