Idex Hale Sam, Technical Manual

Page: 146 / 223

126
4.11.3 PF Air Cylinder R&R
Perform the Removal portion of paragraph 4.9.2 (page 103), Priming Feature Assembly, and take
the removed assembly to a stable work surface or bench.
Refer to Table 71 for a list of tools and/or consumables required for this procedure.
Table 71. PF Air Cylinder R&R Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Cable Ties (As Required)
Wire Cutter Muffler, Fittings, Or Tubing
<Refer To 538-00100-000>
7/8-in Wrench Cylinder
<Refer To 538-00100-000>
* Wrench
* Wrench sizes NOT provided since fitting sizes vary by manufacturer.
Perform the following to R&R an air cylinder.
Removal
A.
If required, tag and disconnect both air lines.
B. Remove air fitting (elbow closest to PF valve body). See Figure 96.
Figure 96. PF Air Cylinder R&R
C. Using 7/8-in wrench, remove air cylinder (with two [2] thrust washers).
Installation
A.
Place thrust washers over air cylinder mounting threats. See Figure 96.
B. Hand start air cylinder in PF valve.
C. Using 7/8-in wrench, tighten air cylinder.
D. Install air fitting (elbow closest to PF valve body), tighten fitting.
E. Connect both air lines according to tags.
Perform the Installation portion of paragraph 4.9.2 (page 103), Priming Feature Assembly.