Idex Hale Sam, Technical Manual

Page: 169 / 223

149
Figure 127. TS Outputs Screen – Pre-Prime #1 Active
4.15.3.2 Testing MIV Inputs
When an Input is triggered, the red bubble turns green. See Table 75 below for how to trigger the
corresponding inputs.
Table 75. MIV–A Input Testing
Button Name Function Comments
Button 1 LH MIV Button Input Press and hold button
Button 2 RH MIV Button Input Press and hold button
Button 3 RH BOT MIV Button Input Press and hold button
Water Detect Water Detect Input See section 4.15.2 for water detect testing
If the desired function does not work verify power, harness connection, and CAN connection to
the component. If all three items are good, replace the component under test.
4.15.4
Testing Priming And Air Bleed Component (CAN Inputs)
Test ABV solenoid valves (CAN outputs) as follows.
A.
Select CAN Outputs.
B. Select corresponding output to be tested. See Table 76 and Figure 128.
Table 76. Priming And Air Bleed Component Testing
Name Air Bleed Output
MIV #1 Left Side MIV
MIV #2 Right-Side MIV
MIV # 3 Right Bottom MIV
MIV # 4 T-port MIV
MIV # 5 Left Bottom MIV
MIV # 6 Remote Mounted MIV