Idex Hale Sam, Technical Manual

Page: 85 / 223

65
The LIGHTED PB SWT # X (X = 1 thru 3) four [4] pin Deutsch connector (female) connects to the
corresponding MIV-Auto Module harness, LIGHTED PUSHBUTTON SWT # X connector (Male) and
the primary MIV–A module. See Table 22 for the MIV activation button from/to wire listing.
NOTE
If equipped with a fourth master intake valve, connect the fourth MIV Activation Button
per 513-00145-004 (This harness is only used when four or more master intake valves
are specified.) to the slave MIV–A module.
Table 22. MIV Activation Button Wiring (From/To Listing)
From Auto MIV Button #
Connector Pin
To (Primary) MIV–A Module
Connector : Pin To Breaker Box
LH MIV (PB SWT # 1)
1 (SYSTEM POWER)
N/C Connector 3, Pin 1
2 (SW MOMENTARY) A : 6 (SW-1 MOMENTARY) [Input] N/C
3 (SW LED) B : 5 (PB SW LED #1) [Output] N/C
4 (SYSTEM GROUND) N/C Main Ground Stud *
RH MIV (PB SWT # 2)
1 (SYSTEM POWER)
N/C Connector 3, Pin 4
2 (SW MOMENTARY) A : 7 (SW-2 MOMENTARY) [Input] N/C
3 (SW LED) B : 8 (PB SW LED #2) [Output] N/C
4 (SYSTEM GROUND) N/C Main Ground Stud *
Bottom MIV (PB SWT # 3)
1 (SYSTEM POWER)
N/C Connector 3, Pin 4
2 (SW MOMENTARY) A : 8 (SW-3 MOMENTARY) [Input] N/C
3 (SW LED) B : 6 (PB SW LED #3) [Output] N/C
4 (SYSTEM GROUND) N/C Main Ground Stud *
T-Port MIV (PB SWT # 4) To Slave MIV–A Module Pin
1 (SYSTEM POWER) N/C Connector 3, Pin 1
2 (SW MOMENTARY) A : 6 (SW-1 MOMENTARY) [Input] N/C
3 (SW LED) B : 5 (PB SW LED #1) [Output] N/C
4 (SYSTEM GROUND) N/C Main Ground Stud *
* Located on pump body.