Idex Hale Sam, Technical Manual

Page: 127 / 223

107
Table 59. Air Bleed Valve (Solenoid) Wiring (From/To Listing)
From ABV
Pin
To MIV 2.0 Drive Module
Pin
Circuit Breaker Box
Connector 1– Pin
A System Power N/C 4 (Bottom MIV)
1 (LH MIV)
4 (RH MIV)
1 (T-Port MIV)
B Earth Ground N/C N/C
C ABV Solenoid — 6 ABV Solenoid — [Output] N/C
Refer to Table 60 for a list of tools and/or consumables required for this procedure.
Table 60. Air Bleed Valve (Solenoid) Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
Wire Cutter Cable Ties (As Required)
7/16-in Wrench Loctite 580 (Or Equivalent)
9/16-in Wrench Loctite 243 (Or Equivalent)
5/8-in Wrench ABV (Solenoid)
<See FSG-PL-01501, -01502, -01503,
Sheet 5 thru 7>
13/16-in Wrench
(Optional, see NOTES below.)
Check Valve
<See FSG-PL-01501, -01502, -01503,
Sheet 5 thru 7>
Mounting Clamp
<See FSG-PL-01501, -01502, -01503,
Sheet 5 thru 7>
If an ABV solenoid fails or is damaged; replace the solenoid as follows.
Removal
A.
Note cable tie locations, cut ONLY ties required to R&R solenoid.
B. At solenoid, tag and disconnect electric connector.
C. Tag and disconnect air bleed tubing (3/8-in POH connections).
NOTES
If access permits, the screw securing the mounting clamp to the bracket may only need
to be loosened allowing the solenoid to slide out of the mounting clamp.
If access does NOT permit the removal of the check valve and POH fitting with the
solenoid in place, remove the entire assembly and then secure the solenoid in a vise
or hold the solenoid by the body using the optional 13/16-in wrench.
D. Using 5/8-in wrench, remove check valve (including POH adapter) from solenoid.
E. Using 9/16-in wrench, remove POH adapter from solenoid.