Idex Hale Sam, Technical Manual, Page: 87 / 223

67
Installation
A.
Remove nut from rear of new switch, cable assembly, and connector.
B. Align and push switch thru panel.
C. Install nut. (Slip nut over connector and cable assembly.)
D. Using 1-in wrench , tighten nut. (Do NOT over tighten.)
E. Connect wiring according to tags.
F. Install cable ties cut to R&R switch as noted.
4.4.9 Optional Navigator Controllers
Refer to Akron Brass 126914, Style 9335 Navigator Pro With Pressure, Flow CAFS And Valve
Control Installation, Operating, And Maintenance Instructions and/or 123250, Style 9325 Navi-
gator Pro With Pressure, Flow CAFS And Valve Control Installation, Operating, And Maintenance
Instructions for all aspects of maintenance for a Navigator Pro controller.
Refer to the drawings listed in FSG-MNL-00212, SAM Parts Manual, Table 1, Optional Compo-
nent/Item, Navigator for connection, connector pat numbers, and SAM compatible Navigator part
information.
4.5.
Removal And Replacement Of Akron Brass Valves
The following subparagraphs provide reference to or information and instruction for the Akron
Brass motorized Swing-Out™ valves used for the SAM system. SAM utilizes both Gen 1 and/or
Gen 2 valves and as long as physical space allows the valves are interchangeable.
AN OFF-THE-SHELF AKRON BRASS SWING-OUT
TM
VALVE WILL NOT FUNCTION IN A
HALE SAM SYSTEM. DO NOT USE ONE FOR SUBSTITUTION OR REPLACEMENT PUR-
POSES.
4.5.1 Recording SAM System Information Parameters
IF THE SAM SYSTEM IS TURNED OFF IN CONFIGURATION MODE, WHEN TURNED ON,
THE SYSTEM WILL RETURN TO CONFIGURATION MODE. THIS MAY CAUSE A PROBLEM
FOR AN END USER (FIREFIGHTER). ALWAYS REBOOT TO THE GUI BEFORE TURNING
THE SYSTEM OFF.
Prior to physically removing an Akron Brass valve, perform the following to access and record the
system parameters associated with that valve.
A.
On SAM Control Center, touch MANUAL MODE button. See Figure 1 (page 11).
B. Touch YES button. (See Figure 2.)
C. On rear of SAM Control Center, connect USB Key to USB dongle. See Figure 24.
D. On SAM Control Center, touch and hold system options button until loading icon
completes circle. (See Figure 25, page 34.)
E. When password screen is displayed (see Figure 26), enter OEM/Technician pass-
word. (All OEM/Technician passwords are ONLY provided at Hale training.)
F. Touch BAM tab.
G. Touch Configuration Menu button.