Idex Hale Sam, Technical Manual

Page: 208 / 223

188
6.1.2 How To Set Units
SAM automatically sets the SAM Control Center Units to match the SAM Pump Controller setting
when the Pump Controller units are changed. To see how to change/set the units for the Pump
Controller, see paragraph 4.12.3.2 (page 135).
6.1.3
Setup And Configurations Using The BAM Tab (Configuration Mode)
The following subparagraphs provide information/instruction to configure a SAM system using
the SAM Configuration Mode screens.
6.1.3.1
Setup And Configurations Using The Device Select Menu
Many of the following assignments/settings can only be accessed by an OEM, apparatus builder,
or a Hale FAST center. Many of the fields listed in this section are critical to the proper operation
of the SAM system.
A majority of the SAM system setup and configuration is accomplished using the System Options
Menu, Configuration Mode. Perform the following to begin the SAM system setup and configura-
tion.
A.
Access Select Device screen (Figure 158) as follows.
Perform Accessing SAM Password Screens (see paragraph 2.6.1, page 33).
Enter Technician Level 2 password.
Touch BAM tab. See Figure 103, page 133.
Touch Configuration Mode button. SELECT DEVICE MENU (Figure 158) is displayed.
Figure 158. SELECT DEVICE MENU Screen