![background image](http://html2.mh-extra.com/html/icom/id-800h/id-800h_instruction-manual_3781017017.webp)
■
Programming memory channels
X
QUICK REFERENCE GUIDE
Quick reference guide
The ID-800H has a total of 512 memory channels (including
10 scan edges and 2 call channels) for storing often used op-
erating frequency, repeater settings, etc.
1. Setting a frequency
In VFO mode, set the desired operating frequency with re-
peater, tone and tuning steps, etc.
➥
Push
[V/MHz•SCAN]
to select VFO.
➥
Rotate
[DIAL]
to set the desired frequency.
• Set other data, such as repeater tone, duplex information, tuning
step, if desired.
2. Selecting a memory channel
Push
[S.MW•MW]
, then rotate
[DIAL]
to select the desired
memory channel.
• “
!
” indicator and memory channel number blink.
3. Writing a memory channel
Push and hold
[S.MW•MW]
for 1 sec. to program.
• 3 beeps sound
• Return to VFO mode automatically after the program.
• Memory channel number automatically increases when continuing
to push
[S.MW•MW]
after programming.
Using the HM-133
q
In VFO mode, set the desired operating frequency, includ-
ing offset direction, tone settings, etc.
➥
Push
[VFO/LOCK]
to select VFO.
➥
Push
[
ENT
C(T-OFF)]
first, then enter the desired oper-
ating frequency via the keypad.
• Set other data, such as repeater tone, duplex information,
tuning step, if necessary.
w
Push
[FUNC]
then
[
CLR
A(MW)]
.
• “
!
” indicator and memory channel number blink.
e
Push
[
Y
Y
]
/
[
Z
Z
]
to select the desired memory channel.
r
Push
[FUNC]
then push and hold
[
CLR
A(MW)]
for 1 sec.
to program.
• 3 beeps sound
• Memory channel number automatically increases when continu-
ing to push
[
CLR
A(MW)]
after programming.
Push ,
then
[S.MW•MW]
ID-800H_1.qxd 2007.06.14 3:09 PM Page X