26
4
REPEATER OPERATION
4
■
Offset frequency
[
When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
Independent offset frequencies can be set for each operating
frequency.
q
Push
[BAND•MODE]
and rotate
[DIAL]
, then push
[BAND•MODE]
to select the desired frequency band.
w
Select the desired mode/channel you wish to set the offset
frequency, such as VFO mode or memory/call channel.
• The offset frequency can be independently programmed into
each mode or channel.
e
Push
[SET•LOCK]
to enter set mode.
• Rotate
[DIAL]
to select “SET,” if “CALLS” or “MESSAG” is dis-
played.
r
Push
[SET•LOCK]
or
[S.MW•MW]
until “DUP” and offset
frequency appear.
t
Rotate
[DIAL]
to set the desired offset frequency.
y
Push any key (other than
[V/MHz•SCAN]
) below the dis-
play to exit set mode.
z
Push
[BAND]
and
[
Y
Y
]/[
Z
Z
]
, then push
[BAND]
to select the desired band.
• Enter the desired frequency via the keypad if neces-
sary.
x
Select the desired mode/channel you wish to
set the offset frequency, such as VFO mode or
memory/call channel.
• The offset frequency can be independently pro-
grammed into each mode or channel.
c
Push
[
SET
B(D-OFF)]
to enter set mode.
• Push
[
Y
Y
]
or
[
Z
Z
]
to select “SET,” if necessary.
v
Push
[
SET
B(D-OFF)]
or
[
ENT
C(T-OFF)]
until
“DUP” and offset frequency appear.
b
Push
[
Y
Y
]
or
[
Z
Z
]
to set the desired offset.
• Direct frequency entry from the keypad is not possible.
n
Push
[
CLR
A(MW)]
to exit set mode.
NOTE:
The offset frequency can be set in a memory/call
channel temporarily. However, the set frequency is cleared
once another memory channel or VFO mode is selected.
To store the offset frequency permanently, overwrite the
channel information.
Push
SET
B
[SET•LOCK]
“DUP” and offset frequency appear
ID-800H_1.qxd 2007.06.14 3:09 PM Page 26
