63
11
DIGITAL MODE OPERATION
D
D
Station call sign programming
Station call sign must be programmed for the specified sta-
tion call as well as repeater operation in both digital voice and
low-speed data communications.
q
Push
[SET•LOCK]
to enter call sign set mode.
• Rotate
[DIAL]
to select “CALLS,” if “SET” or “MESSAG” is dis-
played.
w
Push
[SET•LOCK]
or
[S.MW•MW]
several times to select
“UrCALL,” then push
[BAND•MODE]
.
e
Rotate
[DIAL]
to select the desired call sign channel.
• “U” indication blinks.
• “U01” to “U99” are available.
• The call sign “CQCQCQ” is preprogrammed in the channel “U- -.”
r
Push
[BAND•MODE]
for 1 sec. to select call sign pro-
gramming mode.
• The 1st digit blinks.
t
Rotate
[DIAL]
to select the desired character or code.
• Push
[SET•LOCK]
or
[S.MW•MW]
to move the cursor right or
left, respectively.
y
Push
[SET•LOCK]
to select 2nd digit, then rotate
[DIAL]
to select the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming station call sign.
u
Push
[BAND•MODE]
for 1 sec. to save the call sign.
i
Rotate
[DIAL]
to select an another channel from “U01” to
“U99.”
o
Repeat steps
e
to
u
to program other station call sign
channels.
!0
Push one of
[TONE•T-SCAN•BK]
,
[LOW•DUP]
or
[MONI•DTMF•EMR]
to exit call sign set mode.
NOTE:
During the call sign programming mode (
r
to
y
),
push
[V/MHz•SCAN]
to clear the entered call sign
(the cur-
sor returns to the 1st digit position)
, push
[V/MHz•SCAN]
again to select “CQCQCQ,” “/” and the previously saved
call sign.
ID-800H_1.qxd 2007.06.14 3:09 PM Page 63
