![background image](http://html2.mh-extra.com/html/icom/id-800h/id-800h_instruction-manual_3781017028.webp)
11
SETTING A FREQUENCY
2
■
Preparation
D
Turning power ON/OFF
➥
Push and hold
[PWR]
for 1 sec. to turn power ON and OFF.
D
Operating frequency band selection
The ID-800H has 2 m and 70 cm bands for transmission and
reception. In addition, extra frequency bands 127, 220, 350,
500 and 900 MHz bands are available for wide-band receiver
capability (except Taiwan and Korean version).
➥
Push
[BAND•MODE]
and rotate
[DIAL]
, then push
[BAND•MODE]
to select the desired frequency band.
➥
Push
[BAND]
and
[
Y
Y
]/[
Z
Z
]
, then push
[BAND]
to select the desired band.
D
VFO and memory modes
The transceiver has 2 basic operating modes: VFO mode and
memory mode. Select VFO mode first to set an operating fre-
quency.
➥
Push
[V/MHz•SCAN]
to select VFO mode.
• When VFO mode is already selected, the digit below 10 MHz
(the digit below 1 MHz or 100 kHz disappear depending on ver-
sions) disappear. In this case, push
[V/MHz•SCAN]
again (or
twice or 3 times depending on version).
➥
Push
[M/CALL•PRIO]
to select memory mode.
• “
!
” indicator appears when memory mode is selected.
➥
Push
[VFO/LOCK]
to select VFO mode.
➥
Push
[MR/CALL]
to select memory mode.
VFO/LOCK
[V/MHz•SCAN]
[M/CALL•PRIO]
Appears
BAND
[BAND•MODE]
[PWR]
Note that in this manual, sections beginning with a micro-
phone icon (as above), designate operation via the HM-133
microphone.
ID-800H_1.qxd 2007.06.14 3:09 PM Page 11