71
11
DIGITAL MODE OPERATION
z
Push
[
SET
B(D-OFF)]
to enter call sign set mode.
• Push
[
Y
Y
]
or
[
Z
Z
]
to select “CALLS,” if necessary.
x
Push
[
SET
B(D-OFF)]
or
[
ENT
C(T-OFF)]
several
times to select the call sign item, then push
[BAND]
.
• “RPT1 C” or “RPT2 C” appears for repeater call sign.
c
Push
[
Y
Y
]
or
[
Z
Z
]
to select the desired call sign
channel.
• “r01” to “r54” appears.
v
Push
[BAND]
for 1 sec. to enter call sign pro-
gramming mode.
• The 1st digit blinks.
b
Push
[
Y
Y
]
or
[
Z
Z
]
to select the desired character or
code.
• Push
[
SET
B(D-OFF)]
or
[
ENT
C(T-OFF)]
to move the
cursor right or left respectively.
n
Push
[
SET
B(D-OFF)]
to select 2nd digit, then
push
[
Y
Y
]
or
[
Z
Z
]
to select the desired character or
code.
• The 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming other station call
signs.
m
Push
[BAND]
for 1 sec. to save the call sign.
,
Push
[
Y
Y
]
or
[
Z
Z
]
to select an another channel
from “r01” to “r54.”
.
Repeat
v
to
m
to program other station call sign
channels.
⁄0
Push
[
CLR
A(MW)]
to exit call sign set mode.
NOTE:
During the call sign programming mode (
v
to
n
),
push
[VFO/LOCK]
to clear the entered call sign
(the cursor
returns to the 1st digit position)
, push
[VFO/LOCK]
again to
select the previously saved call sign.
IMPORTANT!
The “
!
” indicator appears when the se-
lected call sign channel is used for some memory or call
channels. The desired call sign can be over-written even
the “
!
” indicator is displayed, however, “MR
✱
” is dis-
played while
[BAND•MOD]
(or
[BAND]
)
is pushed and the
previously memorized setting in memory or call channels
are also changed at the same time.
SET
B
ID-800H_1.qxd 2007.06.14 3:09 PM Page 71
