13
2
SETTING A FREQUENCY
■
Tuning step selection
[
Tuning steps are the minimum frequency change increments
when you rotate
[DIAL]
or push
[
Y
Y
]
/[
Z
] on the microphone.
Independent tuning step for each frequency bands can be set
for individual tuning convenience. The following tuning steps
are available.
• 5 kHz*
• 6.25 kHz*
• 10 kHz
• 12.5 kHz
• 15 kHz
• 20 kHz
• 25 kHz
• 30 kHz
• 50 kHz
• 100 kHz
• 200 kHz
*Not selectable in 900 MHz band.
NOTE:
For convenience, select a tuning step that matches
the frequency intervals of repeaters in your area.
q
Push
[BAND•MODE]
and rotate
[DIAL]
, then push
[BAND•MODE]
to select the desired frequency band.
• Push
[V/MHz•SCAN]
to select VFO mode, if necessary.
w
Push
[SET•LOCK]
to enter set mode.
• Rotate
[DIAL]
to select “SET,” if “CALLS” or “MESSAG” is dis-
played.
e
Push
[SET•LOCK]
or
[S.MW•MW]
several times until “TS”
appears as shown below.
r
Rotate
[DIAL]
to select the desired tuning step.
t
Push any key below the display to exit set mode.
z
Push
[BAND]
and
[
Y
Y
]/[
Z
Z
]
, then push
[BAND]
to
select the desired frequency band.
• Push
[VFO/LOCK]
to VFO mode, if necessary.
x
Push
[
SET
B(D-OFF)]
to enter set mode.
• Push
[
Y
Y
]
or
[
Z
Z
]
to select “SET,” if necessary.
c
Push
[
SET
B(D-OFF)]
or
[
ENT
C(T-OFF)]
several
times until “TS” appears.
v
Push
[
Y
Y
]
or
[
Z
Z
]
to select the desired tuning
step.
b
Push
[
CLR
A(MW)]
to exit set mode.
NOTE:
During the “6.25 kHz” tuning step selection, the op-
erating frequency indication below 1 kHz, 0.25 kHz and
0.75 kHz indications, won’t be displayed on the function
display.
Indication example;
When 145.03125 MHz
is set.
SET
B
[SET•LOCK]
ID-800H_1.qxd 2007.06.14 3:09 PM Page 13
