48
7
SCAN OPERATION
7
■
Scan resume condition
The scan resume condition can be selected as timer or pause
scan. The selected resume condition is also used for priority
watch.
(p. 50)
q
Push
[SET•LOCK]
to enter set mode.
• Rotate
[DIAL]
to select “SET,” if “CALLS” or “MESSAG” is dis-
played.
w
Push
[SET•LOCK]
or
[S.MW•MW]
several times until
“SCT” or “SCP” appears as shown above.
• When “d” is displayed in place of the 100 MHz digit, cancel the
DTMF memory encoder in advance. (p. 53)
e
Rotate
[DIAL]
to set the desired timer:
• “SCT-15”
: Scan pauses 15 sec. while receiving a signal.
• “SCT-10”
: Scan pauses 10 sec. while receiving a signal.
• “SCT-5”
: Scan pauses 5 sec. while receiving a signal.
• “SCP-2”
: Scan pauses until the signal disappears and then
resumes 2 sec. later.
r
Push any key below the display to exit set mode.
[
z
Push
[BAND]
and
[
Y
Y
]/[
Z
Z
]
, then push
[BAND]
to
select the desired band.
x
Push
[
SET
B(D-OFF)]
to enter set mode.
• Push
[
Y
Y
]
or
[
Z
Z
]
to select “SET,” if necessary.
c
Push
[
SET
B(D-OFF)]
or
[
ENT
C(T-OFF)]
several
times until “SCT” or “SCP” appears as shown at
left.
v
Push
[
Y
Y
]
or
[
Z
Z
]
to select the scan resume condi-
tion.
• See item
e
at left for scan resume condition details.
b
Push
[
CLR
A(MW)]
to exit set mode.
SET
B
The display shows that the
scan will resume 15 sec. after
it stops.
ID-800H_1.qxd 2007.06.14 3:09 PM Page 48
