![background image](http://html2.mh-extra.com/html/icom/id-800h/id-800h_instruction-manual_3781017019.webp)
2
1
PANEL DESCRIPTION
1
u
MONITOR•DTMF•EMR SWITCH [MONI•DTMF•EMR]
➥
Push to switch the monitor function ON and OFF.
(p. 16)
❍
While in the analog (FM) mode operation
➥
Turns DTMF memory encoder ON and OFF when
pushed and held for 1 sec.
(p. 51)
❍
While in the digital (DV) mode operation
➥
Push and hold to turn the EMR function ON and OFF.
(p. 87)
i
OUTPUT POWER•DUPLEX SWITCH [LOW•DUP]
➥
Each push changes the output power selection.
(p. 19)
➥
Push and hold for 1 sec. to select DUP–, DUP+ and
simplex operation.
(p. 21)
o
TONE•TONE SCAN•BREAK-IN SWITCH
[TONE•T-SCAN•BK]
❍
While in the analog (FM) mode operation
➥
Each push selects a tone function.
(pgs. 21, 55)
• Subaudible tone encoder, pocket beep (CTCSS), tone
squelch, pocket beep (DTCS), DTCS squelch or tone func-
tion OFF can be selected.
➥
Push and hold for 1 sec. to start the tone scan.
(p. 59)
❍
While in the digital (DV) mode operation
➥
Each push selects a digital squelch function.
(pgs. 85,
86)
• Pocket beep (DSQL), digital call sign squelch, pocket beep
(CSQL), digital code squelch or digital squelch function
OFF can be selected.
➥
Push and hold until 2 short and 2 long beeps sound
to turn the break-in function ON.
(p. 84)
!0
MEMORY/CALL•PRIORITY SWITCH [M/CALL•PRIO]
➥
Push to select and toggle memory, call and weather
channel* modes.
(pgs. 11, 28, 40, 111)
*Weather channels are available for USA version only.
➥
Starts priority watch when pushed and held for 1 sec.
(p. 50)
!1
VFO/MHz TUNING•SCAN SWITCH [V/MHz•SCAN]
➥
Selects and toggles VFO mode and 1 MHz
(or 10 MHz
for some versions)
tuning when pushed.
(pgs. 11, 12)
➥
Starts scan when pushed and held for 1 sec.
(p. 43)
• Cancels a scan when pushed during scan.
!2
BAND•MODE SWITCH [BAND•MODE]
➥
While VFO operation, push to select the operating fre-
quency band.
(p. 11)
➥
While call channel operation, push to select the call
channel 1or 2 during call channel operation.
(p. 40)
➥
While memory channel operation, push to select mem-
ory bank condition.
(p. 37)
➥
Push and hold for 1 sec. and rotate
[DIAL]
to select the
operating mode.
(p. 15)
!3
MEMORY WRITE SWITCH [S.MW•MW]
(pgs. 29, 41, 45)
➥
Selects a memory channel for programming when
pushed.
➥
Programs the selected memory channel when pushed
and held for 1 sec.
!4
CONTROLLER RELEASE LATCH
While pushing this latch, slide the controller to the left to
remove it.
ID-800H_1.qxd 2007.06.14 3:09 PM Page 2