![background image](http://html2.mh-extra.com/html/icom/id-800h/id-800h_instruction-manual_3781017087.webp)
70
11
DIGITAL MODE OPERATION
11
■
Digital repeater operation
Repeater call sign must be programmed for repeater opera-
tion in both digital voice and low-speed data communications.
D
D
Repeater call sign programming
q
Push
[SET•LOCK]
to enter call sign set mode.
• Rotate
[DIAL]
to select “CALLS,” if “SET” or “MESSAG” is dis-
played.
w
Push
[SET•LOCK]
or
[S.MW•MW]
several times to select
either the repeater call sign item, “RPT1 C” or “RPT2 C,”
then push
[BAND•MODE]
.
• “RPT1 C” or “RPT2 C” appears for repeater call sign.
e
Rotate
[DIAL]
to select the desired call sign channel.
• “r01” to “r54” appears.
r
Push
[BAND•MODE]
for 1 sec. to enter call sign program-
ming mode.
• The 1st digit blinks.
t
Rotate
[DIAL]
to select the desired character or code.
• Push
[SET•LOCK]
or
[S.MW•MW]
to move the cursor right or
left, respectively.
y
Push
[SET•LOCK]
to select 2nd digit, then rotate
[DIAL]
to select the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming repeater call sign.
u
Push
[M/CALL•PRIO]
to turn the gateway setting ON, if
desired.
• “G” indication appears as the 8th digit.
• Add the gateway setting only when programming a gateway re-
peater call sign with gateway connection usage.
i
Push
[BAND•MODE]
for 1 sec. to save the call sign.
o
Rotate
[DIAL]
to select an another channel from “r01” to
“r54.”
!0
Repeat steps
r
to
u
to program other repeater call sign
channels.
!1
Push one of
[TONE•T-SCAN•BK]
,
[LOW•DUP]
or
[MONI•DTMF•EMR]
to exit call sign set mode.
NOTE:
During the call sign programming mode (
r
to
u
),
push
[V/MHz•SCAN]
to clear the entered call sign
(the cur-
sor returns to the 1st digit position)
, push
[V/MHz•SCAN]
again to select the previously saved call sign.
ID-800H_1.qxd 2007.06.14 3:09 PM Page 70