![background image](http://html2.mh-extra.com/html/icom/id-800h/id-800h_instruction-manual_3781017068.webp)
■
Programming a DTMF code
DTMF tones are used for autopatching, controlling other
equipment, etc. The transceiver has 16 DTMF memory chan-
nels (D0–DF) for storage of often-used DTMF codes of up to
24 digits.
q
Push
[MONI•DTMF]
for 1 sec. to turn the DTMF encoder ON.
• “d” appears in place of 100 MHz digit.
— For U.S.A. version only! —
In DV mode, make sure to release the button just after the sec-
ond beep. Holding the button too long (for too many beeps) will
send the radio into EMR mode (see “Be careful!,” below).
• Push and hold
[MONI•DTMF]
until 1 short and 1 long beeps
sound to turn the DTMF memory encoder OFF. Again, do not
hold button past 2 beeps.
Be careful!:
EMR mode is turned ON when pushing and holding
[MONI•DTMF]
until 4 beeps sound.
w
Push
[SET•LOCK]
to enter the DTMF memory program-
ming condition.
• The DTMF memory channel indication blinks.
e
Rotate
[DIAL]
to select the desired DTMF memory channel.
r
Push
[SET•LOCK]
.
• The first digit blinks.
t
Rotate
[DIAL]
to select the desired code.
y
Push
[SET•LOCK]
to select the next digit.
• Pushing
[S.MW•MW]
moves the cursor backward.
u
Repeat the steps
t
and
y
to set the desired DTMF tone
sequence.
• The S/RF indicator shows the digit group. The indication in-
creases every 6 digits.
i
Push any key below the display to exit DTMF memory pro-
gramming condition.
• Return to the previous indication as in step
q
.
D
Programming a DTMF code— via microphone
z
Push
[FUNC]
then
[
LOW
6(DTMF)]
to turn the
DTMF encoder ON.
• “d” appears in place of 100 MHz digit.
x
Push
[
SET
B(D-OFF)]
to enter the DTMF mem-
ory programming condition.
c
Push
[
Y
Y
]
or
[
Z
Z
]
to select the desired DTMF
memory channel.
v
Push the desired digit keys.
• When the first digit is input, previous memory con-
tents are cleared automatically.
• “E” stands for “
M
M
” and “F” stands for “# .”
• Push
[
Y
Y
]
/
[
Z
Z
]
and repeat this step if you make a mistake.
• The S/RF indicator shows the digit group. The indi-
cation increases every 6 digits.
b
Push
[VFO/LOCK]
to exit the programming con-
dition.
•
[
CLR
A(MW)]
key cannot be used to exit. If pushed,
code “A” is input. Reprogram in such a case.
DTMF
51
DTMF MEMORY ENCODER
9
ID-800H_1.qxd 2007.06.14 3:09 PM Page 51