IBM P 615 series, Service Manual

Page: 212 / 491

Service Processor Error Codes
Attention: Follow the procedure defined in the “Checkpoint and Error Code Index” on page 162. If you
replace FRUs or perform an action and the problem is still not corrected, go to “MAP 1548: Processor
Subsystem Problem Isolation” on page 113 unless otherwise indicated in the tables.
If you replace FRUs and the problem is corrected, go to
″
MAP 0410: Repair Checkout
″
in the RS/6000
Eserver
pSeries Diagnostic Information for Multiple Bus Systems .
Table 6. Service Processor Error Codes.
Error Code Description Action/
Possible Failing FRU
406x 0002 CEC backplane fault CEC backplane
Location: U0.1-P1
406x 0003 Scan interface basic assurance tests detected
processor fault
CEC backplane
Location: U0.1-P1
406x 000E Processor capacity card Operator panel
Location: U0.1-L1
406x 0010 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M5
406x 0011 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M7
406x 0012 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M4
406x 0013 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M2
406x 0014 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M6
406x 0015 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M8
406x 0016 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M3
406x 0017 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M1
406x 00B0 Bus controller failure
1. Check for system firmware updates. Apply if
available.
2. Replace the service processor, location:
U0.1-P1-X1
3. Replace the CEC backplane, location:
U0.1-P1
406x 00B1 Bus controller failure
1. Check for system firmware updates. Apply if
available.
2. Replace the service processor, location:
U0.1-P1-X1
3. Replace the CEC backplane, location:
U0.1-P1
192
Eserver
pSeries 615 Service Guide