IBM P 615 series, Service Manual

Page: 203 / 491

Table 5. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
25A8 0100 NVRAM data validation check failed. Turn off, then turn on system unit and retry the
operation before replacing any system
component.
Refer to Action under error code 25A80xxx.
25A8 0201 Unable to expand target partition - saving
configuration variable.
Refer to Action under error code 25A80xxx.
25A8 0202 Unable to expand target partition - writing error
log entry.
Refer to Action under error code 25A80xxx.
25A8 0203 Unable to expand target partition - writing VPD
data.
Refer to Action under error code 25A80xxx.
25A8 0210 Setenv/$Setenv parameter error - name contains
a null character.
Refer to Action under error code 25A80xxx.
25A8 0215 NVRAM RIO-USR-select variable not found
1. Check for platform firmware updates. Apply if
available.
2. Call service support.
25A8 0211 Setenv/$Setenv parameter error - value contains
a null character.
Refer to Action under error code 25A80xxx.
25A8 0998 Description: NVRAMRC script evaluation error - command line execution error
Action: Execution of a command line within the nvram configuration variable “nvramrc” (script)
resulted in a “throw” being executed. This script can be modified by the system firmware SMS
utilities, the operating system, PCI adapter ROM code or utility, or an operator (via the open
firmware script editing command nvedit ). It may not be possible to resolve the problem without a
detailed analysis of the nvram script, the current system configuration, and device tree contents.
1. The problem can be caused by a SCSI adapter, whose SCSI bus ID has been changed from
the default setting, no longer appearing in the system. This can be caused either by removing a
SCSI adapter, or a problem with a SCSI adapter.
a. Select option 5, Change SCSI Settings , on the SMS main menu. Then on the SCSI utilities
menu, select option 2, Change SCSI Id .
1) Verify the list of SCSI controllers/adapters. If the list is not correct, suspect a problem
with the adapter(s) installed but not listed.
2) Select one of the adapters listed and enter the SCSI id that is currently displayed for
that adapter, then exit from this menu. This causes the information in NVRAM to be
updated.
3) Restart the system.
b. If the problem persists, boot the operating system and verify the SCSI bus IDs of any
installed/available SCSI controllers (change as necessary), and restart the system.
2. Contact your support representative for further assistance.
25A8 0999 NVRAMRC script evaluation error - stack
unbalanced on completion
This is a firmware debug environment error.
There is no user action or FRU replacement for
this error.
25A8 0A00 Unable to retrieve NVRAM LPAR table
information
Refer to the actions column for error code 25A8
0xxx.
Chapter 5. Error Code to FRU Index
183