IBM P 615 series, Service Manual

Page: 207 / 491

Table 5. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
1. Power off the system. See “Removing a Non-Hot-Pluggable PCI Adapter” on page 294 and “Replacing or
Installing a Non-Hot-Pluggable PCI Adapter” on page 296 for instructions on reseating the card. If reseating the
adapter fixes the problem, go to
″
MAP 410, Repair Checkout
″
in the RS/6000
Eserver
pSeries Diagnostic
Information for Multiple Bus Systems manual.
Attention: Before moving the adapter to another slot, verify with the customer or system administrator that the
slot that the adapter is being moved to is in the partition in which the adapter presently resides.
2. Is there an empty slot available into which the adapter could be plugged?
YES Move the adapter to another slot behind a different PCI bridge. The “System Logic Flow” on page 23
identifies the PCI bridges and the associated slots. See “Removing a Non-Hot-Pluggable PCI Adapter”
on page 294 when removing the adapter, and “Replacing or Installing a Non-Hot-Pluggable PCI Adapter”
on page 296 when installing the card in the new slot. If the card is successfully reconfigured in the new
slot (behind a different PCI bridge), the slot in which the card was originally plugged is bad. Replace the
CEC backplane, location: U0.1-P1. If the adapter does not reconfigure successfully in the new slot,
replace the adapter.
NO Replace the adapter. If the problem is not resolved, replace system backplane in which the card was
installed, location: U0.1-P1.
3. Go to “MAP 1548: Processor Subsystem Problem Isolation” on page 113.
If the location code does not identify a slot or PCI adapter, or no location code is specified, go to “MAP 1548:
Processor Subsystem Problem Isolation” on page 113.
2602 0011 Description: PCI probe error, bridge is not usable
Action: If the location code identifies a slot:
1. Check the cabling to the adapter, in particular, the adapters that have serial ports. Serial ports
may require null modems or special cabling configurations to avoid connecting driver outputs
together. This may create a PCI slot power problem and force the adapter to be deconfigured.
Attention: Before moving the adapter to another slot, verify with the customer or system
administrator that the slot that the adapter is being moved to is available to the partition in
which the adapter presently resides.
2. Move adapter to another slot (behind a different PCI bus).
3. Check for available firmware updates for adapter. Apply update if available.
4. Replace the adapter.
5. Check for system firmware updates. Apply update if available.
6. If the card is in the system drawer, replace the system backplane, location: U0.1-P1. If the card
is in an I/O subsystem, replace the I/O backplane that contains the slot in which the adapter
was originally installed, location: U0.dd-P1.
2602 0012 Description: PCI device run-time error, bridge in freeze state
Action: If the location code identifies a slot:
1. Check the cabling to the adapter. In particular, the adapters that have serial ports. Serial ports
may require null modems or special cabling configurations to avoid connecting driver outputs
together. This may create a PCI slot power problem and force the adapter to be deconfigured.
2. Move adapter to another slot (behind a different PCI bus).
3. Check for available firmware updates for adapter. Apply update if available.
4. Replace adapter.
5. Check for system firmware updates. Apply if update available.
6. If the card is in the system drawer, replace the CEC backplane, location: U0.1-P1. If the card is
in an I/O subsystem, replace the I/O backplane that contains the slot in which the adapter was
originally installed, location: U0.dd-P1.
Chapter 5. Error Code to FRU Index
187