IBM P 615 series, Service Manual

Page: 209 / 491

Table 5. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
2803 0001 RTC not updating - RTC initialization required
1. Set time and date.
2. Refer to Action under error code 2803 0xxx.
2803 0002 Bad time/date values
1. Set time and date.
2. Refer to Action under error code 2803 0xxx.
2803 0003 RTC not updating - not correctable Replace service processor
Location: U0.1-P1-X1
2803 0004 RTC operating mode parameters (eg. data
mode) changed
1. Set time and date.
2. Refer to Action under error code 28030001.
2803 0005 RTC battery error
1. Replace the battery.
Note: Password, time, and date need to be
set.
2. Refer to Action under error code 2803 0001.
2803 F003 Real-time-clock not updating - not correctable
(detected by hypervisor)
Replace the service processor
Location: U0.1-P1-X1
2900 0002 Keyboard/mouse controller failed self-test Replace service processor
Location: U0.1-P1-X1
29A0 0003 Keyboard not present/detected
1. Keyboard
2. Replace service processor
Location: U0.1-P1-X1
29A0 0004 Keyboard stuck key detected
1. Keyboard
2. Replace service processor
Location: U0.1-P1-X1
29B0 0004 Mouse not present/detected
1. Mouse
2. Replace service processor
Location: U0.1-P1-X1
2B20 0011 Processor is manually disabled Use the service processor menus to re-enable
the processor and reboot the system
2B20 0012 This is an informational code that is generated
when the AIX cpu_deallocate command is used
to take a processor off-line.
There is no action required.
To bring the processor back on-line (back into
the system’s or partition’s configuration), reboot
the operating system.
2B20 0022 Processor is deconfigured by the system The processor has previously failed BIST or
POST. Replace the processor card indicated by
the location code associated with the error code
in the error log.
2B20 0031 Processor is failing POST. Replace the processor card indicated by the
location code associated with the error code in
the error log.
2B20 0042 Unknown processor card Remove the unknown/unsupported CEC
backplane.
Chapter 5. Error Code to FRU Index
189