IBM IntelliStation M Pro 6218, Problem Determination And Service Manual

Page: 96 / 168

Installing the front adapter-retention bracket
To install the front adapter-retention bracket, complete the following steps:
1. Feed the speaker wire through an opening in the bottom of the
adapter-retention bracket.
2. Engage the lower retention tabs of the adapter-retention bracket with openings
in the chassis and tilt the bracket toward the front of the computer (see
Figure 15).
3. Press the two retention tabs at the top of the adapter-retention bracket through
the openings in the front of the computer until they lock securely.
4. Reconnect the speaker wire to the system board connector.
5. Install any full-length adapters that were removed.
6. Install the front bezel (see “Installing the bezel” on page 78).
7. Install the hard disk drive bracket, if one was removed (see “Installing the hard
disk drive bracket” on page 97).
8. Install the side cover (see “Installing the side cover” on page 76).
9. Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Release tabs
Figure 15. Installing the front adapter-retention bracket
80
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide