IBM IntelliStation M Pro 6218, Problem Determination And Service Manual

Page: 72 / 168

11. Disconnect all power cords; then, remove the computer cover and hard disk
drive bracket (if one is installed).
12. Remove any adapters that impede access to the jumper; then, return the boot
block recovery jumper to pins 1 and 2.
13. Replace any adapters that were removed; then, replace the hard disk drive
bracket (if one was removed) and the cover.
14. Reconnect all external cables and power cords.
15. Turn on the attached devices and turn on the computer to restart the operating
system.
Small computer system interface (SCSI) error codes (some models)
For any SCSI error message that you receive when running the SCSISelect Utility
program, one or more of the following devices might be causing the problem:
v A failing SCSI device (adapter, drive, controller)
v
An incorrect SCSI configuration
v
An incorrectly installed cable
v A defective cable
For any SCSI error message, follow these suggested actions in the order in which
they are listed until the problem is solved:
v
Make sure that the external SCSI devices are turned on before you turn on the
computer.
v Make sure that the cables for all external SCSI devices are connected correctly.
v
Make sure that the SCSI devices are configured correctly.
If the problem remains, run the diagnostic programs to obtain additional information
about the failing device.
Note: If the computer does not have a SCSI hard disk drive, ignore any message
that indicates that the BIOS code is not installed.
56
IBM IntelliStation M Pro Type 6218 and 9236: Problem Determination and Service Guide