IBM Aptiva 2198, Reference Manual

Page: 99 / 186

3. Remove the drive bay panel in front of bay 2 by inserting a flat-blade
screwdriver in the cutout along the left edge of the panel and prying
slightly to the left. Continue with step 4 on page 77.
4. Disconnect the signal and power cables from the rear of the drive.
5. Remove the two mounting screws that secure the drive in place.
Mounting screws
6. Slide the drive forward through the front of the computer and remove
the drive.
7. To reinstall the drive, reverse this procedure.
Note: If you are replacing an IDE drive with a new drive, make sure
that the drive settings (master or slave) on the replacement drive
are the same as the drive you are replacing.
Chapter 7. Installing internal options
77