IBM Aptiva 2198, Reference Manual

Page: 100 / 186

Removing a drive from bay 3
To remove the diskette drive from bay 3:
1. Move the power supply aside to gain access to the drive mounting
screws. See “Moving the power supply” on page 61.
2. Disconnect the signal and power cables from the rear of the drive.
3. Remove the two mounting screws that secure the drive in place.
Mounting screws
4. Remove the processor by spreading the lower retaining clips at each
end of the processor, and then carefully lifting the processor straight out.
Set the processor aside.
78
Aptiva Reference Guide