IBM Aptiva 2198, Reference Manual

Page: 91 / 186

automatically. However, there are circumstances in which you must use the
Configuration/Setup Utility program to configure a PCI adapter. For
information about these circumstances, see “Configuring PCI adapters” on
page 84.
Note: If you install an audio adapter, you must disable the system-board
audio, using the Configuration/Setup Utility program. The only
exception to this is if you install an Aureal Audio PCI Adapter in PCI
slot 1. In this case, the adapter is automatically detected and the
system-board audio is disabled.
Some adapters require device drivers and other support software, which
usually ship with the adapter. The method of installing device drivers varies;
so, always follow the instructions in the documentation provided with the
adapter to install any device drivers and support software.
Installing adapters
Before you begin:
Ÿ
Read “Safety information” on page vii and “Handling static-sensitive
devices” on page 57.
Ÿ
Read the instructions that come with the new adapter.
Ÿ
Turn off the computer and all other connected devices.
Ÿ
Disconnect all power cords and external cables attached to the
computer, and then remove the computer cover (see “Removing the
cover” on page 59).
To install an adapter:
1. Move the power supply aside if necessary. See “Moving the power
supply” on page 61.
2. Remove the screw and slot cover for the appropriate expansion slot.
3. Remove the adapter from its static-protective package.
4. Install the adapter into the appropriate slot on the system board.
5. Install the screw that secures the adapter.
Chapter 7. Installing internal options
69