IBM 60, User Manual

Page: 64 / 166

vertical and horizontal positions (to move the point of origin down and to the right).
The figure below shows the result of changing the vertical position to +7 and the
horizontal position to +6.
Determining If You Need to Adjust Print
Before making any adjustments, determine if you need to adjust the print. That is,
run a print test to see if you need to change the point of origin on a page by adding
to, or subtracting from, the vertical and horizontal starting positions.
Note: This procedure assumes a defined form is loaded in the printer, the form is
assigned to the tray in TRAYS/STACKERS, and a job is waiting to be run. The test
pages printed consists of the next pages in the printer data stream. If no job is
waiting, no pages print.
To run a test print to determine if the print needs to be adjusted, do the following:
1. Press the Stop key (if printer is READY) to temporarily stop any current print
jobs and to make the printer NOT READY.
2. Press the Menu/Exit key to enter menu mode.
3. Scroll to the SETUP menu, and press the Enter key. Enter the key operator
password, if prompted.
4. Scroll to ADJUST PRINT, and press the Enter key.
5. Scroll to the form you want to adjust, and press the Enter key.
6. Scroll to the side you want to adjust, and press the Enter key.
7. If you want to specify the number of pages desired for the print test, scroll to
NUMBER OF PAGES, and press the Enter key. Use the keyboard to specify
the number of copies.
8. If you want to specify the stacker, scroll to STACKER, and press the Enter key.
Scroll to the desired stacker, and press Enter to make the selection. Press the
Enter key again to return to the submenu.
4-22
InfoPrint 60 User's Guide