IBM 5400-006, Setup And Operator Manual

Page: 36 / 210

Connecting to the Host System
1.3.2 Connecting to a PC (Using a Parallel Port)
The default format is for connecting to an AS/400 system. After setting the inter-
face port format item to a parallel port, connect the interface cable.
Interface Cable (Printer Cable)
Ÿ
Printer cable is sold separately
– ID# 81X7875 (2.4 m)
– ID# 09F5544 (5.0 m)
Ÿ
The printer cable has 36 pins on the printer side and 25 pins on the system
side. A 36
∼
36 pin cable cannot be used.
Interface Port Settings
Change the printer connection to PC.
1
Connect the power cord to the outlet and set the Power switch to the (
│
) side.
The power turns on. (See 2.3.1, “Powering On” on page 2-9.)
2
Press Set Up Mode. The following message is displayed:
3
Press Set Up Mode again. The following message is displayed:
à ð
Interface Port
System Port
á ñ
If the message goes too far, press Line Feed until it returns.
1-26
IBM 5400-006 Printer: Setup Instruction and Operator's Guide