Setting the Power Cord
1.2.2
Setting the Power Cord
1
Open the rear door.
2
Take the cover off of the hole in the back left part of the stacker. Push the
cover from below with your hand to take it out. (This cover is not used
again.)
3
Insert the power cord plug into the power connector on the top left of the
stacker and thread the power cord through the hole in the bottom. Then, fix
the cable with the three cable clamps.
Note: Pull the power cord out from the hole in the left of the stacker outside
the printer with the shortest length. If the power cord is loose inside the
stacker, it may cause a stacker jam.
Note:
Use a power plug with three prongs. Do not plug a three-prong power cord into
a two-prong power plug. This might cause poor printing.
Chapter 1. Installation
1-7
Summary of Contents for 5400-006
