IBM 4400 Series, User Manual, Page: 260 / 326

Chapter 15
Complete Command List
260
NOTE: If the
set
prefix is used, a
save
command must be
executed as well so that the new settings are retained after
power cycles. Since
set
only affects the settings in
memory, they will be lost after a power cycle unless they
are saved to flash memory.
Getting Command Help
The Ethernet Interface command shell provides several online help
tools, including:
“?” Command
Typing “ ? ” when logged in to the command shell will produce a full
list of all available commands.
Command Prefixes
Typing in the first portion of a command will produce an error
message showing the correct syntax. For example, typing in
store
tcpip
will produce a list of all commands that start with this prefix.
Complete Command List
This section outlines the entire Ethernet Interface command set
including the command syntax, a description, and in most cases, an
example for each command listed.
NOTE: If you see the word
ifnum
in any npsh commands, you
should substitute a
1
unless told otherwise. This
1
represents the one network interface (e.g., Ethernet)
supported.