HP 8711C, User Manual, Page: 440 / 530

I
Reference
S
in the menu. Displays menu to set bandwidth of in
Bandwidth
receiver section of network analyzer.
See “lb Reduce the Receiver Noise Floor” and the table below for more
information on system bandwidth.
System BW
Dynamic Range Sweep Speed
Wide
Fastest
Medium Wide Medium Faster
Medium Medium
Medium Narrow Medium Slow
Narrow High Slower
Fine High Slowest
Approximate BW
6500 Hz
4000 Hz
3700
Hz
1200 Hz
250 Hz
15 Hz
in [
SYSTEM OPTIONS
]
menu. Displays menu to adjust clock setting, set
beeper volume, adjust CRT settings, and configure the rear panel USER TTL
port.
in menu. Makes the network analyzer the system controller of
the HP instrument bus. Required mode for interfacing with peripherals
(printers, plotters, and disk drives). Also required by to talk to
peripherals. This operation mode is not selectable with another active
controller on the bus.
See the Guide for more information.
Access Keys:
OPTIONS
]
[
SYSTEM OPTIONS
)
in SYSTEM area of front panel.
in the cal kit menu. Provides access to the system impedance menu.
Refer to “When to Change the System Impedance” in Chapter 3 for more
information.
Access Keys: Cal Kit;
9-77
深圳市盛腾仪器仪表有限公司
Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com