Higen FDA7000 Series, Operation Manual

Page: 100 / 214

3. Parameter setting
3-21
P02-39
＊
Extra DB Control
Unit
-
Setting range
0 ~ 2
Manufactured
default
OFF
Speed/Torque/
Position control
The signal for controlling the dynamic brake installed outside the servo drive can be output.
* To use this function, set DB MODE (P02-09) parameter first, and set Function No. (20)
to the desired CN1 pin number using P08 menu.
* This function only applies to Special Order products that can connect external DB.
Value
Function
0
Do not use external DB control
1
External DB Control Signal Output (Normal Open Type)
2
External DB Control Signal Output (Normal Close Type)
P02-40
＊ ENC CNT ERR TC
Unit
ms
Setting range
0 ~ 10000
Manufactured
default
5
Speed/Torque/
Position control
When a 17-bit serial encoder is used, the count error detection time of the encoder can be set.
* If P02-40 = 0, the count error alarm function is disabled.
[When using FDA7000EX( Explosion-Proof ) Series]
P02-40
Motor OVER TEMP
Unit
-
Setting range
ON / OFF
Manufactured
default
OFF
Speed/Torque/
Position control
Some explosion-proof motor models have a built-in temperature sensor (PTC), and an alarm
(Ano-22) is output when the motor overheats. If you do not use the over temperature alarm
with this sensor, you can disable the alarm function by setting P02-40 = ON.
If P02-40 = ON, the temperature sensor signal of the motor is not connected to the drive,
an alarm (AL-22) will occur.
OFF
Enable motor over temperature alarm
ON Disable the motor over temperature alarm function
[When using FDA7002EX( Explosion-Proof )]
P02-41
Motor OVR TEMP TC
Unit
ms
Setting range
100 ~ 9000
Manufactured
default
100
Speed/Torque/
Position control
You can set the overheat alarm detection time of the motor with a built-in temperature sensor.