HarmonicDrive H A - 800A, Manual

Page: 163 / 314

6-1 Operating display panel
6-10
11
10
9
4
7
6
5
4
3
2
1
Panel
di
spl
ay and oper
at
io
n
How to set output signals (SP20 to 26)
* For details on output signals, refer to P5-26.
Example) Assigning [03: Alarm output] to pin 17 of CN2
Logic circuit setting 01→00
Set value of output signal 02→03
Logical set value
00: Normally open
01: Normally closed
UP MODE DOWN S E T
Set value of output signal
Assign one of 00 to 22.
UP MODE DOWN SET
UP MODE DOWN S E T
UP MODE DOWN S E T
DOWN
Press the SET button when the
set value of the parameter is
shown, and the fourth and fifth
digits of the set value will flicker.
(The values set in the fourth and
fifth digits can now be changed.)
Press the SET button and release it before the flickering stops
(within approx. 1 second), and the change will be cancelled.
The fourth and fifth digits can be
changed. Pressing the UP button
changes the set value. (Press and
hold each button to change the
value faster.)
Example)
Changing the set value from 2 to 3
The second and third digits can
be changed. Pressing the UP
button changes the set value.
(Press and hold each button to
change the value faster.)
Example)
Changing the logical set value
from 01 to 00
Press the SET button and release it after
the flickering has stopped (approx. 1
second) to make the set value effective.
SET
SET
SET
SET
UP MODE DOWN S E T
UP MODE DOWN S E T