Preparing to Cut
♦
C3 - 23
SET 14
zz
CONDITION 2 30
4
CB09Ux 0
SET 14
CONDITION 2 30
zz
4
CB09Ux 0
Cutter Conditions
To change the setting of a group of conditions, press the function key [F1] through [F4]
corresponding to the number of the group you wish to change. For example, press the F2 key to
select CONDITION 2.
Press the CONDITION key to get into the condition menu.
Press the NEXT key to cancel the condition where you are currently set and return to
the main menu.
NOTE:
If the Tangential emulation mode is enabled for the condition number that you are
currently working on, the overcut menu appears as soon as the ENTER key is pressed.
Change the values, if necessary.
For details see Tangential Emulation
.
To Change the Cutter Force
Press the F1 key to change FORCE. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 35.
Press the F2 key to change SPEED.
Press the F3 key to change QUALITY.
Press the F4 key to change OFFSET.
Press the ENTER key to register your setting.
To Change the Cutter Speed
Press the F2 key to change SPEED. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 90 and +. [1 to 10, 15, 20,
25, 30, 35, 40, 45, 50, 55, 60, 70, 80, 90, +.]
The “+” is 126cm/sec speed.
NOTE:
The “+” selection is available with firmware version 1.13 or later.
Press the F1 key to change FORCE.
Press the F3 key to change QUALITY.
Press the F4 key to change OFFSET.
Press the ENTER key to register your setting.
Summary of Contents for Cutting Pro FC4100-100
Page 1: ...cutting pro FC4100 series series USER S MANUAL 1 a...
Page 138: ...Setting the Interface Functions C7 7 Input Output Circuitry Input Output Timing Chart...
Page 147: ...Specifications C8 6 FC4100 100 without Stand FC4100 100 with Stand Standard and Basket Option...
Page 148: ...Specifications C8 7 FC4100 130 without Stand FC4100 130 with Stand Standard and Basket Option...
