GRAPHTEC Cutting Pro FC4100-100, User Manual

Page: 104 / 169

Background Settings
♦
C5 - 6
MEDIA SIZE SENSOR
ENABLED
\ \
DISABLED
PINCH ROLLER SENSOR
ENABLED
\ \
DISABLED
PEN UP MOVE
ENABLED
DISABLED
\ \
MEDIA SIZE SENSOR
ENABLED
\ \
DISABLED
Pen UP Movement Control (PEN UP MOVE)
When the Plotter receives commands that specify consecutive pen movements in raised status,
the PEN UP MOVE function determines whether to move the pen to each coordinate point or to
move the pen directly to the final coordinate point.
When ENABLED is selected, the pen moves to each coordinate point in sequence.
When DISABLED is selected, the pen moves directly to the final coordinate point.
Press the F3 key to select ENABLED.
Press the F4 key to select DISABLED.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.
Media Size Sensor Control
This function allows you to disable the media length sensor function which is performed after
selecting the media type during the plotter’s initialization.
When ENABLED is selected, the media length sensor is performed.
When DISABLED is selected, the media length sensor will not perform.
In cases where the media length is disabled, the pen carriage may go beyond the edge of the
media. Always set the AREA function to limit the cut area and protect the cutting mat from
damage.
Press the F3 key to select ENABLED.
Press the F4 key to select DISABLED.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.