X400CE 3D Printer Manual
Seite:
79/245
Stand:
2015/08/28 11:55
© German RepRap GmbH
79/245
idler pulley and the stepper motor and then tension it via the other “Belt Clamp”. Only then, the rest
of the timing belt is cut off and the same procedure is done on the other side of the motor.
Details mounting 1
Details mounting 2
Make sure the opto flag moves into the end stop without touching it.
Once the toothed belt is installed, tighten the screws of the guiding rod holder in the Y-axis carriage.
It's important to avoid any torsion or bend on the guiding rods to minimize the friction for the carriage.
