X400CE 3D Printer Manual
Seite:
148/245
Stand:
2015/08/28 11:55
© German RepRap GmbH
148/245
Finish cable
Insulation (Heated bed)
This section only needs to be performed when the X400 is assembled with a heated bed!
Insulation parts overview
Number Description
2
Corrugated board, 400x400mm
1
PET tape 460×460 mm
For thermal insulation of the bottom, two layers of corrugated board is put on the heating pad and
tightly taped with PET. The holes for the screws have to be cut out.
In case
ABS
is printed in the future, the surface of the printing bed has to be covered with a
layer of PET tape as well, so it is easier to remove the
ABS
from the printing bed later on.
One layer is enough, without overlapping or bubbles if possible (as these contours would later be
visible on the bottom of the printed part).
