X400CE 3D Printer Manual
Seite:
66/245
Stand:
2015/08/28 11:55
© German RepRap GmbH
66/245
Number Description
1
M3x45 cylinder head screw
1
L-ALU opto flag Y
5
M3 washer
1
M3 locking nut
Small tin strips are being used to cut off the light to the optical sensor. The one for the y axis is
installed at the X-glider with the idler pulley.
Next install the X-glider clamp on the side where the pulley is. Later we'll fasten the toothed belt to
the clamp.
Attach the L-ALU opto flag Y on the oppsite side using four washers.
Don't tighten the screws just yet as we need to first insert the LM12UU bearings.
Finish Opto-Flag Y
