X400CE 3D Printer Manual
Seite:
169/245
Stand:
2015/08/28 11:55
© German RepRap GmbH
169/245
Number Description
1
M3x16 cylinder head screw
2
M3 washer
1
M3 self-locking nut
The “frame cable mount” or cable mount holder, supports the fabric tube from the extruder to the
electronics box. It needs to be attached to the rear frame profile using two screws and T-slot nuts.
Insert the cables and then the fabric tube into the holder and slide the holder up into position on the
frame.
Cable holder with fabric tube
Secure the fabric tube using cable ties and cable tie holders on the frame as shown.
The picture shows the cable mount marked in red and the cable ties and holders marked in yellow.
Attachment fabric tube
Clamp the cable holder using the M3 screw, washer and nut to prevent movement of the fabric tube.
Installation spacer profiles
This step is only applicable for the X400CE!
