X400CE 3D Printer Manual
Seite:
49/245
Stand:
2015/08/28 11:55
© German RepRap GmbH
49/245
Details Z-Guides
Now it's time to screw the “Z-Guides” on the trapezoidal rods. All three guides should be at about the
same height.
Also make sure that the guiding rods can be inserted without any friction (not shown in picture).
Details assembly Z-Guides
To finish this step, insert the guiding rods in the frame and through the Z-guides, then secure them
with the adjusting ring. If necessary, deburr the guiding rods using sand paper. Also if the adjusting
ring doesn't slide onto the rod easily, deburr the inside of the ring where the thread for the grub
screw was cut.
