X400CE 3D Printer Manual
Seite:
25/245
Stand:
2015/08/28 11:55
© German RepRap GmbH
25/245
Z-guide, right
Basic information
Before starting the assembly, we will address some basic points.
Alignment: This chapter addresses the alignment of the printer. Make sure to stick to the indicated
●
measurements.
Drilling: The holes inside some PP-plastic parts might be too small. If the screw or rod is not
●
smooth-running through the hole, we recommend to enlarge the hole to a matching size.
Optional extras: This manual covers the main unit as well as all optional components.
●
Screws and nuts: While installing screws and nuts please make sure not to over-tighten them.
●
Otherwise components might be damaged or increased friction might result, particularly on the
bearings.
Washers: Washers are used to spread the forces of a screw head, a screw or the nuts on a larger
●
space.
Hence it is recommended to always use washers unless indicated otherwise, e.g. when using
countersunk head screws or sunk cylinder head screws.
Cabling: It is important to follow the circuit diagrams included in this manual lest property or
●
personal damage may result.
In case of doubt, please seek professional help before commissioning!
Work on the 230 V mains power supply should only be carried out by trained and certified electricians.
Property or personal damage or death may be caused by an improper installation, which the installer
bears the liability for.
Proper handling of the chemicals necessary for maintenance and care is obligatory, as well as
complying with the applicable regulations and operation notes regarding the chemicals. Directions of
the manufacturer have to be followed at all times and appropriate protective clothing has to be worn.
Property or personal damage may be caused by improper use of the chemicals, which the operator
alone bears liability for.
