X400CE 3D Printer Manual
Seite:
217/245
Stand:
2015/08/28 11:55
© German RepRap GmbH
217/245
bed. Using the software move the pencil 100mm on the X- and Y-axis and measure the lines drawn,
as seen in the first picture “Skipping steps” If the lines are less than the amount you moved the
extruder, there is still some slipping of the stepper motor. You can repeat the process over the whole
length of the printing bed, starting from the home position. This also allows to check the vertical
alignment of the printing bed. The second photo shows the lines whithout any slipping “No skipping”.
Slipping can also occur if the motor current is set too high.
Skipping steps
No skipping
The calibration process is finished once the potentiometers are set correctly.
