X400CE 3D Printer Manual
Seite:
122/245
Stand:
2015/08/28 11:55
© German RepRap GmbH
122/245
You only need this chapter to mount a DD-Extruder and SLS-Parts.
Assembly extruder parts overview
Number Description
1
Direct-Drive extruder single, pre-assembled
4
M3x60 cylinder head screw
12
M3 washer
Additional parts for the Dual-Extruder
Number Description
1
Direct-Drive extruder single, pre-assembled
4
M3x60 cylinder head screw
12
M3 washer
The additional parts for the Dual-Extruder are marked with a blue rectangle
The four screws on the back of the stepper motor have to be removed. For the X400, they are no
longer being used.
It is recommended to prepare the 4 new screws in the carriage before removing the 4 old ones. Then
immediately secure the motor with the new screws. If not, there is a chance that the motor housing
itself opens up. If that happens, carefully put it back together.
preparation stepper motor
The new cylinder head screws are assembled with three washers each and are inserted into to the
