GE 001C 051D 003A, Service Manual

Page: 57 / 282

Equipment overview: Theory of operation
2000966-542D Dash 3000/4000/5000 2-37
Single battery run time: approximately 2.5 hours – An icon fully
outlined with solid lines and completely filled indicates a new battery,
fully charged to its Design Capacity.
Single battery run time: approximately 2.0 hours – The dotted
portion of the icon outline shows that the battery has lost 20% of its
Design Capacity. The solid-outline portion is filled in, showing that the
battery is charged to 100% Full Charge Capacity.
Single Battery Run Time: Approximately 1.0 Hours – The dotted
portion of the icon outline shows that the battery has lost 20% of its
Design Capacity. The solid-outline portion is half filled in, showing that
the battery is charged to only 50% of available capacity.
Identify battery capacity using the Cadex SMart Two+
charger
NOTE
The Cadex SMart Two+ charger is no longer available for purchase.
However, if your site has a Cadex SMart Two+ charger, you should
continue to use it to charge and condition the battery.
When you select the Target Capacity switch on the charger, the
charger compares the battery’s performance to a 60%, 70%, or 80% target
capacity set on the battery charger. If the battery fails to meet the target
performance, the battery charger will prompt you to condition the
battery. If after the condition cycle has been completed, the battery does
NOT meet the target performance, then the battery charger will
illuminate a “fail” light.
857A
Design Capacity and Full Charge Capacity
858A
Full Charge Capacity
859A
Full Charge Capacity
50% Available Capacity