Foma PushTalk SH902i, Manual

Page: 205 / 568

203
B
ar Co
d
e Read
er
Camera
1
In stand-by, press
t921
.
Alternatively, select
;
(Camera) or
.
(Life
tool)
→
Bar code reader from Top menu.
Or, press
C14
[Bar code reader] in
the still picture shooting screen (
n
P. 180).
Bar code reader mode is activated.
Position the camera approximately 10 cm
from the bar code (JAN/QR code). Keep
aligned and do not move the FOMA terminal
or code while scanning.
2
Display bar code (JAN/QR code) to be read in the center of the
screen.
FOMA terminal automatically distinguishes between JAN code and QR code.
Glossy paper may be difficult to read. Adjust angle so light does not reflect
directly into camera.
3
Press
t
[Scan].
Focus lock is automatically set if not already set when scanning.
Bar code reader starts scanning code (JAN/QR code). When scanning is
complete, an end tone is heard and scan results appear.
If one minute passes after scanning starts and nothing is scanned, Could not
read appears and the screen of step 2 reappears.
To cancel scanning, press
i
[Break] or
c
. Scanning is interrupted and the
screen of step 2 reappears.
4
Select scanned text and press
t
.
Scanned characters and numbers are selectable if underlined.
Based on the type of scanned text, confirmation screens for i-mode connection (for URLs), compose
message (for mail addresses) or phone (Videophone) confirmation screen (for phone numbers) appears.
Applicable screens appear for scanned data. Add to phonebook screen for phonebook data, compose
message screen for mail data, register bookmark screen for bookmark data, and run i-
α
ppli screen for
i-
α
ppli data.
If scanned characters and numbers are not underlined, display does not change even if
t
is pressed.
Note
Alternatively, press
C63
[Bar code reader] in the URL entry screen or text entry screen for a site
(
n
steps 1 to 3 on P. 215) to activate Bar code reader.
Saving phonebook entries is not available while phonebook PIM is locked. Enter terminal security code
(four to eight digits) to unlock temporarily and save scanned text to phonebook. PIM lock is enabled again
after saving.
When Manner mode or Public mode (Drive mode) is set, Focus lock sound and scan complete tone do not
sound.
Approx. 10 cm
To use Picture light Press
i
[Light].
To lock focus Press
s
.
Hard-to-scan codes may be recognized. A
beep sounds when focused.
To view saved data Press
C2
.
To switch focus modes Press
C3
.
To copy all scanned text Press
i
[Copy all].
To copy a part of scanned text Press
C3 →
select origin
→ t
[Start]
→
select last
→ t
[Copy].
To save scanned data Press
C4 →
select save destination
→ t
.
Save up to five entries.
dv30̲e.book Page 203 Tuesday, November 22, 2005 3:21 PM