Fluke 1586A, User Manual

Page: 135 / 140

Error Messages and Troubleshooting
Error Messages
7
7-17
Table 7-1. Error Messages (cont.)
Error Code Error Message Causes and Solutions
Error 825 LAN address invalid
Cause: Invalid IP, mask or gateway address was found.
Solution: Check the address and try again.
Error 826
LAN hostname
invalid
Cause: The hostname contains invalid character. The
Instrument only allows ‘A’ to ‘Z’, ‘0’ to ‘9’ and ‘-‘.
Solution: Check the parameter and try again.
Error 827
LAN hostname too
long
Cause: More than 20 characters were found when
configuring hostname.
Solution: Check the parameter and try again.
Error 828
LAN connection
timeout
Cause: The LAN connection has been disconnected.
Solution: Check the LAN equipment and try to connect
again.
Error 901
File not found
Cause: File not found for memory operation.
Solution: Check to make sure the file is in the memory.
Error 903 Error exporting file
Cause: Failed while exporting file to USB memory.
Solution: Make sure that the USB memory is not write
protected and that the USB memory has enough free space.
Error 904 Error deleting file
Cause: Failed while deleting file.
Solution: If you are delete file from USB memory, make sure
that the USB memory is not write-protected.
Error 905 Error reading file
Cause: The file has been damaged.
Solution: Cycle the power. If the error occurs again, contact
Fluke (see Chapter 1).
Error 906
Error defining setup
file name
Cause: Duplicate filename was found.
Solution: Try another name or remove the file with the
conflict.
Error 907 Error reading folder
Cause: Folder not exist.
Solution: Make sure that the folder is in the memory.
Error 908 Error writing file
Cause: Failed while writing file.
Solution: Make sure that the USB memory is not write
protected and that the USB memory has enough free space.
Error 909 File already exists
Cause: The destination already exists while a file with the
same name.
Solution: Try another name or remove the file with the
conflict.