Flexim FLUXUS G704, User Manual, Page: 142 / 257

142 UMG70XV3-4EN 12.01.2009
15 Settings
15.2.5 Steam in Inlet
15.2.6 Temperature Correction
15.2.7 Error Value Delay
The error value delay is the time after which an error value will be sent to an output if no
valid measured values are available.
15.2.8 Alarm State Indication
15.3 Measurement Settings
Select
ON
if the medium in the supply line may be vapor-
ous for the heat flow measurement of a liquid medium. In
the program branch
PARAMETER
, the supply pressure has
to be entered then.
Select
ON
to enter a temperature correction for each tem-
perature input (see section 17.5).
Select
EDIT
to enter an error value delay. Select
DAMPING
if the damping factor is to be used as error value delay.
For further information on the behavior of missing mea-
sured values see section 18.1.2 and 18.2.
Select
ON
to display the alarm state during measurement.
Fur further information on alarm outputs see section 18.5.
Note!
All changes will be stored now at the end of the dialog.
Select in
SPECIAL FUNCTION\SYSTEM SETTINGS
the
list item
MEASURING
. Press ENTER.
Note!
The settings of the menu item
MEASURING
will be stored at the end of
the dialog. If the menu item is quit before the end of the dialog, the
settings will not be effective.
Select
ON
to activate the gas measurement,
OFF
to deacti-
vate it. Press ENTER.
Select
YES
to switch on concentration measurement,
NO
to
disable it.
Steam in inlet
off >ON<
Tx Corr.Offset
off >ON<
Error-val. delay
damping >EDIT<
SHOW RELAIS STAT
off >ON<
SYSTEM settings

Measuring
Gas measuring
off >ON<
Enable Concentr.
no >YES<